iRobot Roomba 535 Vacuum Cleaner Manual

The iRobot Roomba 535 is an advanced robotic vacuum cleaner designed to efficiently clean your floors with minimal human intervention. It features a three-stage cleaning system, advanced sensors for navigation, and a compact design that allows it to reach under furniture. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to the Home Base 7. Cleaning Modes 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Three-stage cleaning system, cliff detection sensors, virtual wall barriers, and a compact design for easy navigation.

Feature	Description
Three-stage cleaning system	Cleans carpets and hard floors effectively.
Cliff detection sensors	Prevents falls from stairs and ledges.
Virtual wall barriers	Keep Roomba in designated areas.
Compact design	Allows access under furniture and tight spaces.
Rechargeable battery	Automatically returns to the Home Base to recharge.

Installation

Unpack and inspect contents. Place the Home Base on a flat surface near a power outlet.

Connect the Home Base to power.
Ensure the area is clear of obstacles for Roomba to navigate.
Charge Roomba for at least 3 hours before first use.

WARNING! Keep the charging area clear to avoid damage.

First-Time Setup

Power on Roomba; follow the voice prompts for setup.

Press the CLEAN button to start the initial cleaning cycle.
Set the clock and schedule cleaning times if desired.
Familiarize yourself with the controls and settings.

CAUTION! Ensure Roomba is on a flat surface during setup.

Specifications

Model: Roomba 535.
Cleaning System: Three-stage cleaning.
Battery: Rechargeable lithium-ion.
Run Time: Up to 90 minutes on a full charge.
Dimensions: 13.9 x 13.9 x 3.6 inches.
Weight: 7.9 lbs.
Noise Level: 60 dB.

Controls and Settings

Access controls via the top panel: CLEAN, SPOT, DOCK, and SCHEDULE buttons.

Remote: Use the remote control for additional features and scheduling.

Settings include cleaning modes, scheduling options, and battery status.

Connecting to the Home Base

Ensure Roomba is aligned with the Home Base for charging.

Place Roomba within 1-2 feet of the Home Base.
Press the DOCK button to send Roomba back to the Home Base.
Ensure the Home Base is plugged in and the indicator light is on.

Tip: Keep the area around the Home Base clear for optimal charging.

Cleaning Modes

Roomba offers multiple cleaning modes including Auto, Spot, and Scheduled cleaning.

Auto mode: Cleans the entire area.
Spot mode: Cleans a small, targeted area.
Scheduled mode: Cleans at designated times.

WARNING! Do not use Roomba on wet surfaces.

Maintenance

Regularly clean the brushes and empty the dustbin for optimal performance.

CAUTION! Unplug the Home Base before performing maintenance.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Roomba does not charge	Home Base not plugged in	Check power connection to Home Base.
No suction	Clogged brushes/dustbin	Clean brushes and empty dustbin.
Roomba gets stuck	Obstacles in the way	Clear the area of obstacles.
Remote not working	Batteries dead	Replace batteries in the remote.

Reset: Press and hold the CLEAN button for 10 seconds to reset.

Service: For support, contact iRobot customer service.