iRobot ROOMBA 5500 Vacuum Cleaner Manual

The iRobot ROOMBA 5500 is a robotic vacuum cleaner designed to autonomously clean your floors. Equipped with advanced sensors, it navigates around furniture and obstacles, ensuring a thorough cleaning experience. The ROOMBA 5500 features multiple cleaning modes, a scheduling function, and a self-charging capability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Vacuum 8. Maintenance and Care 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Advanced sensors, multiple cleaning modes, scheduling function, self-charging capability.

Feature	Description
Advanced Sensors	Detects dirt and obstacles for efficient cleaning
Multiple Cleaning Modes	Choose from auto, spot, and edge cleaning
Scheduling Function	Set cleaning times for convenience
Self-Charging Capability	Automatically returns to charging dock when battery is low
HEPA Filter	Traps allergens and fine dust particles
Virtual Wall	Creates boundaries to keep the vacuum in designated areas

Installation

Unpack and inspect contents. Place the charging dock in a clear area.

Connect the charging dock to a power outlet.
Ensure the area around the dock is free of obstacles.
Place the ROOMBA 5500 on the dock to charge before first use.

WARNING! Ensure the dock is plugged in and the vacuum is properly seated for charging.

First-Time Setup

Power on the vacuum; follow the voice prompts.

Set the current time using the buttons on the vacuum.
Program cleaning schedules as desired.
Test the vacuum by initiating a cleaning cycle.

CAUTION! Keep the area clear of small objects to avoid jams.

Specifications

Model: iRobot ROOMBA 5500.
Battery Type: Lithium-ion.
Run Time: Up to 90 minutes on a full charge.
Charging Time: Approximately 3 hours.
Weight: 8.5 lbs.
Dimensions: 13.9 x 13.9 x 3.6 inches.
Filter Type: HEPA filter for allergen capture.
Noise Level: 60 dB during operation.

Controls and Settings

Access settings via the control panel on the vacuum. Use buttons for power, mode selection, and scheduling.

Remote: Optional remote control for manual operation and scheduling.

Cleaning modes: Auto, Spot, Edge. Adjust settings for optimal performance based on your cleaning needs.

Connecting Devices

No external devices are required for operation. Ensure the vacuum is connected to the charging dock.

Turn on the vacuum before use.
Ensure the charging dock is plugged in and functional.

Tip: Keep the charging dock in a location that is easily accessible for the vacuum.

Operating the Vacuum

To start cleaning, press the CLEAN button on the vacuum or use the remote control.

Press CLEAN to initiate a cleaning cycle.
Monitor the vacuum's progress via the indicator lights.
Return the vacuum to the dock after cleaning is complete.

WARNING! Do not obstruct the vacuum during operation.

Maintenance and Care

Regular maintenance is essential for optimal performance.

Empty the dustbin after each use.
Clean the brushes and filters regularly.
Check for tangled hair or debris around the wheels.

CAUTION! Always turn off the vacuum before performing maintenance.

Regulatory Information

This device complies with FCC Part 15. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Vacuum does not start	Battery drained	Charge the vacuum on the dock.
No suction	Full dustbin	Empty the dustbin and clean filters.
Stuck in one place	Obstacles	Clear the area of obstacles.
Remote not working	Batteries dead	Replace batteries in the remote.

Reset: Press and hold the CLEAN button for 10 seconds to reset.

Service: For support, contact iRobot customer service.